After clicking OK, the software will detect any direct (horizontal, vertical or diagonal) connection lines shorter than the specified separation track segments of the correct width will be automatically added to complete a route. UseĪfter launching the command, the Subnet Connector dialog will open and you will be prompted to enter a value for the maximum subnet separation (100mil/2.54mm is the default value) of incomplete routing segments. This command is accessed from the PCB Editor by choosing the Route » Add Subnet Jumpers command from the main menus. An added subnet jumper completes the route between two tracks that have the same net property. This command is used to automatically add subnet connectors to complete the short routing segments (those tracks that still have connection lines in between) on the current PCB document - eliminating the need for the manual completion of such segments.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |